205-621-4321
Fans
New
Rebuild/Repair
Multi-clone Mechanical Dust Collectors
High
Temperature multiple tube dust collectors. Our collectors use high
efficiency bell mouth inlets and peripheral discharge boots for maximum
efficiency.
The Barron Fan Technology Multi-clone Dust Collector provides an efficient and reliable method to remove particulate from your gas stream in order to reduce fan erosion with a minimum of maintenance.
- Bell Mouth inlet
vanes offer a reduced pressure drop and greater resistance to plugging
- Cast Iron tubes
- greater abrasion resistance than fabricated plate
- Offered in fully
accessible or non-accessible designs
- 33 years of continuous
design improvements
- 10" Diameter:
Best used for light dust loads. Provides the greatest efficiency, but
may be more likely to plug at higher grain loads. Normally used in boiler
applications because of its high efficiency.
- 14" Diameter:
Best used as a pre-cleaner for other pollution control equipment when
dust loading is high and abrasive. Less efficient than 10", but
less likely to plug. Commonly used as a pre-cleaner in kiln systems.
- 24" Diameter:
Extremely heavy duty collector used for handling severe abrasives and
high dust loading such as in sintering applications.
Sloped Tube Sheet Multi-clone Collector
In may cases, the accessible design collector is unnecessary or impractical due to space limitations. For non-abrasive dust loads the need for component repair may be low. In these cases, the Sloped Tube Sheet Collector can save money. It is a more compact design requiring less structural support. It uses the same bell mouth tubes for improved efficiency.
Call
us for a comparison & recommendation for your specific application.
Barron
Fan Technology, Inc. " Air Systems Engineers"
200 Industrial Rd. P.O. Box 1883
Alabaster, AL. 35007
205-621-4321 Fax 205-621-1402 sales@barronfan.com
200 Industrial Rd. P.O. Box 1883
Alabaster, AL. 35007
205-621-4321 Fax 205-621-1402 sales@barronfan.com